Car holder - TrueLife Nannycam
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
EN: NannyCam car headrest holder, best printed from CF/GF filament. CZ: Držák NannyCam na opěrku, ideálně tisk z CF/GF f
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 9
- Makes
- 0
- Views
- 92
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
TrueLife NannyCam holder designed for in‑car use. When the baby is sleeping in the car in the driveway, it’s useful to monitor them with a camera. I power the camera using a 10 000 mAh powerbank.
The holder snaps onto the headrest rod. I measured rods in three different cars (Honda, Renault, Citroën) and all had a diameter of 12.6 mm, so the mount is designed primarily for this size. It can also clip onto a thicker rod (tested up to 20 mm), but not onto thinner ones.
For best results, I strongly recommend printing from carbon‑fiber‑ or glass‑fiber‑reinforced filament to prevent creep. Standard PLA works at first, but it will lose clamping force after a few months, especially in summer heat.
Do NOT leave it clipped in the car while driving. It may become dangerous in the event of an accident
Designed to 3 perimeter print with 0.4mm nozzle