1 / 1
Ikea Friheten couch raiser (9 height options: 20-50mm) — zdjęcie 1

Ikea Friheten couch raiser (9 height options: 20-50mm)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Extensions for rising an ikea Friheten couch to a more comfortable height or to allow robot vacuums to clean under.

Ocena
0 / 5
Polubienia
5
Pobrania
31
Wydruki
0
Wyświetlenia
187
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Living Room
Licencja
Creative Commons — Attribution — Share Alike

Introduction

Ever since getting the Ikea Friheten corner couch I was bothered by the fact that my robot vacuum was unable to reach under the couch. Also standing up from a "low" couch is getting harder with age. So I decided to design risers and test them to ensure stability over a longer time.

I've now tested these risers for two years and I am satisfied with the stability. My house has hydronic floor heating (max temperature 35 °C) and the PLA has not warped. I'm 1.82 m and use the 42.5 mm riser.

Warning, based on feedback: I appears Ikea has multiple molds for the legs with different hexagonal openings. This is sized to have 15.588 mm between opposite flat edges and a height of 11.5 mm. On my 2022 Frihetten couch this means it has sufficient play.

Required parts

  • Ikea Friheten couch

  • 3D printed parts

    • 7 risers

    • 4 wheel risers

  • 8 screws of diameter 4 mm or 4.5 mm and a length of [20 mm + riser height] (choose a longer length if you cannot find the exact length).

  • Optionally: anti slip pads.

Printing parameters

  • The parts are designed to print without supports using standard settings.

  • No particular layer recommendations.

  • The files are already oriented for printing.

  • I recommend a high infill of at least 70%, I went 90% rectilinear.

  • Optionally you could use fuzzy skin (on the visible ones I used 0.15 and 0.15 for thickness and point distance at 0.25 mm layer height).

  • Recommended filament is either matte PLA or matte PETG.

Tagi