Flat Mesh Skirts Front for Clicky Clack with BTT HDMI 5

I needed front flat mesh skirts for my 2.4 300mm. I couldn't use the existing version because of the clicky clack door and the BTT HDMI5 I wanted to use.

You need to print the parts like it is described here:

• adjust the modifier in the slicer (change the type to modifier):

  • 0 wall loops, 0 top layers, 0 bottom layers

  • 22% infill, honeycomb, 60° angle (depends on the alignment of your part on the build plate)

  • 0.42 mm line width

• you should get something like this:

BOM:

for each side you need:

• 7 Voron spec heat inserts (4 for the belt cover, one for the bottom panel mount and 2 for connecting the sides to the middle piece

• 4 M3x16 SHCS for the belt covers

• 2 M3x8 SHCS for mounting to the frame

• 1 M3x8 SHCS for the bottom panel mount

• 2 M3x8 BHCS for mounting the middle part to the side

for the screen mount:

• 4 M3x8 BHCS for mounting the cover to the skirt piece (do that first)

• 4 M3x6 BHCS for mounting the screen to the case (do that second)

• 2 M3x8 SHCS for mounting the skirt piece to the frame

Versions:

V1 initial release

V2 I changed the skirts a bit for. I added some strength between the top and bottom, because when you accidentally pick the Voron up and hold onto the skirt, they might brake at the layer lines.

V3 makes them printable without supports and adds a mount for a BTT HDMI5 v1.2 without a hinge. You don't need any special cables, as long as the plugs aren't too fat.

You can still use this hinge instead: