Drain elbow for Vevor 6L ultrasonic cleaner - 3/8" BSP thread
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Extend the drain from a Vevor 6L ultrasonic cleaner so it can drain into a sink.
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 51
- Wydruki
- 1
- Wyświetlenia
- 200
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The Vevor 6L ultrasonic cleaner has a brass ball valve with a 3/8" BSP thread - that's an untapered thread with a 16.6mm major diameter with a 19tpi pitch. While the cleaner comes with a fitting that attaches it to included hose, I have mine right by a sink so don't need that and created this small elbow to allow it to drain nicely into the sink.
While this is designed to fit the Vevor 6L, it should fit anything that uses a 3/8 BSP female thread. In the US, that should be pretty much nothing, but it might be more common in the rest of the world.
Printing instructions
Prints with the threaded portion on the print bed. I used an inner and outer brim but it didn't seem like that was completely necessary. Printed as recommended, it does not need any supports. I printed in PrintedSolid Jessie PETG (mystery orange) with a 0.2mm layer height (0.4mm nozzle) and two shells, but pretty much anything is going to work here. On mine, it started to tighten just as it was almost pointing down, so I was able to get it tight and pointing down, but no idea if that's going to work the same for your printer.