1 / 3
AERECO ALD ZUROH 100 MD retrofit lever for manual open/close — zdjęcie 1
1 / 3

AERECO ALD ZUROH 100 MD retrofit lever for manual open/close

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Retrofit for the AERECO ZUROH 100 MD moisture-controlled external air vent or as spare part for the ZUROH 110 MD

Ocena
0 / 5
Polubienia
0
Pobrania
6
Wydruki
0
Wyświetlenia
43
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Retrofit for the AERECO ZUROH 100 MD moisture-controlled external air vent or as spare part for the ZUROH 110 MD with lever.

The lever in combination with drilling a hole into the cover converts the ZUROH 100 MD to the ZUROH 110 MD and allows manual override of the air vent.

There are three possible positions of the lever:

  • turn fully left (snaps in) - closed (minimum ventilation)

  • turn fully right (snaps in) - open (maximum ventilation)

  • move between left and right (somehow center) - automatic (humidity controlled)

Instructions:

  1. Print the lever with at least 0.4 nozzle and a small layer height (better than 0.2 mm if possible). I printed it with 0.08 mm layer height. Use PLA or PETG, both should work fine.

  2. Take off the cover and drill a 10 mm hole into the cover where there is a lightly visible imprint of the hole from the frame part.

  3. Snap-in the lever into the frame part.

  4. Attach the cover again and you're ready to go control the air vent.

Tagi