1 / 3
AERECO ALD ZUROH 100 MD retrofit lever for manual open/close — image 1
1 / 3

AERECO ALD ZUROH 100 MD retrofit lever for manual open/close

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Retrofit for the AERECO ZUROH 100 MD moisture-controlled external air vent or as spare part for the ZUROH 110 MD

Rating
0 / 5
Likes
0
Downloads
7
Makes
0
Views
50
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

Retrofit for the AERECO ZUROH 100 MD moisture-controlled external air vent or as spare part for the ZUROH 110 MD with lever.

The lever in combination with drilling a hole into the cover converts the ZUROH 100 MD to the ZUROH 110 MD and allows manual override of the air vent.

There are three possible positions of the lever:

  • turn fully left (snaps in) - closed (minimum ventilation)

  • turn fully right (snaps in) - open (maximum ventilation)

  • move between left and right (somehow center) - automatic (humidity controlled)

Instructions:

  1. Print the lever with at least 0.4 nozzle and a small layer height (better than 0.2 mm if possible). I printed it with 0.08 mm layer height. Use PLA or PETG, both should work fine.

  2. Take off the cover and drill a 10 mm hole into the cover where there is a lightly visible imprint of the hole from the frame part.

  3. Snap-in the lever into the frame part.

  4. Attach the cover again and you're ready to go control the air vent.

Tags