1 / 2
DC Motor Hoist Pulley – 6mm Shaft Compatible — zdjęcie 1
1 / 2

DC Motor Hoist Pulley – 6mm Shaft Compatible

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a simple but effective pulley/spool system designed to mount onto a DC geared motor with a 6mm diameter shaft.

Ocena
0 / 5
Polubienia
5
Pobrania
35
Wydruki
0
Wyświetlenia
144
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

This is a simple but effective pulley/spool system designed to mount onto a DC geared motor with a 6mm diameter shaft. I created this to act as a winch for winding rope or cord in robotics and lifting mechanisms.

Key Features:

  • 6mm Shaft Fit: Designed specifically for standard DC geared motor shafts (check your motor's shaft diameter before printing).

  • Secure Locking: The extended hub features a hole for a set screw (M3 recommended) to clamp the pulley firmly onto the motor shaft, preventing it from slipping under load.

  • High Walls: Large flanges ensure the rope stays contained on the spool during operation.

Hardware Required

  • 1x M3 Screw/Bolt: To act as a set screw for locking the hub to the motor shaft.


Print Settings

I printed this with standard settings which provided sufficient strength for lifting tasks.

  • Layer Height: 0.20 mm

  • Infill: 20%

  • Infill Pattern: Gyroid (Good balance of strength and material saving)

  • Supports: use normal (Auto) support type 

  • Material: PLA or PETG

Tagi