DC Motor Hoist Pulley – 6mm Shaft Compatible
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a simple but effective pulley/spool system designed to mount onto a DC geared motor with a 6mm diameter shaft.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 37
- Makes
- 0
- Views
- 147
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution — Share Alike
This is a simple but effective pulley/spool system designed to mount onto a DC geared motor with a 6mm diameter shaft. I created this to act as a winch for winding rope or cord in robotics and lifting mechanisms.
Key Features:
6mm Shaft Fit: Designed specifically for standard DC geared motor shafts (check your motor's shaft diameter before printing).
Secure Locking: The extended hub features a hole for a set screw (M3 recommended) to clamp the pulley firmly onto the motor shaft, preventing it from slipping under load.
High Walls: Large flanges ensure the rope stays contained on the spool during operation.
Hardware Required
1x M3 Screw/Bolt: To act as a set screw for locking the hub to the motor shaft.
Print Settings
I printed this with standard settings which provided sufficient strength for lifting tasks.
Layer Height: 0.20 mm
Infill: 20%
Infill Pattern: Gyroid (Good balance of strength and material saving)
Supports: use normal (Auto) support type
Material: PLA or PETG