WD-40 to Schrader Valve Inflator Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A small adapter that you can print to inflate a WD-40 can if it has run out of air.
- Ocena
- 5 / 5
- Polubienia
- 27
- Pobrania
- 111
- Wydruki
- 2
- Wyświetlenia
- 803
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Garage
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Description
This is an adapter that converts from a female Schrader valve into a WD40 compatible adapter if the WD40 can has run out of air but still has solvent.
There are 2 versions: One without threads and one with threads. Use the model with threads if your pump/compressor/etc. needs the Schrader Valve to be screwed in. You may need to screw the adapter in/out a few times in the model with threads because of print imperfections for consistent screwing.
Print Settings:
100% INFILL! (The adapter needs to handle pressure, so there are no air leaks and no bursting)
CAUTION! You are handling with pressure, be careful!
Insert the adapter as shown in the picture below: (Thinner side - WD-40, Thicker side/Threads side - Schrader Valve)
License: Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International (CC BY-NC-SA 4.0).
You may remix and share this model non-commercially with appropriate attribution. Derivatives must be released under the same license.
https://creativecommons.org/licenses/by-nc-sa/4.0/