CMF Watch 3 Pro Charging Dock — IKEA SKADIS edition
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix charging dock for CMF Watch 3 Pro, adapted for IKEA SKADIS pegboards, consistent with the original design.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 189
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The CMF Watch 3 Pro really impressed me with its price-to-quality ratio — to the point where the perceived quality often feels higher than its price.
This model is a mix of two existing designs:
a charging dock for CMF Watch 3 Pro from makerworld
an IKEA Skadis Fusion 360 Models mounting system
I combined them into a single dock specifically adapted for mounting on an IKEA SKADIS pegboard. While integrating the SKADIS mount, special attention was paid to preserving the original fillet radii and overall geometry, ensuring the final model remains visually and structurally consistent with the original charging dock.
The dock holds the watch securely at the intended angle, maintaining the original proportions and shape defined by the base model. Structural adjustments were made only where necessary to support wall mounting.
Print settings
Seam position
Back
Infill
Pattern: Gradual TPMS-FK
Start density: 1%
End density: 99%
Gradual direction: Y-axis
This infill setup allows:
a strong and rigid rear section and mounting area suitable for SKADIS
a lighter but sufficiently strong front section, even though it is cantilevered
Supports
Strong tree support on build plate is mandatory
The model will not print correctly without supports.
