1 / 10
CMF Watch 3 Pro Charging Dock — IKEA SKADIS edition — image 1
1 / 10

CMF Watch 3 Pro Charging Dock — IKEA SKADIS edition

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Remix charging dock for CMF Watch 3 Pro, adapted for IKEA SKADIS pegboards, consistent with the original design.

Rating
0 / 5
Likes
1
Downloads
32
Makes
0
Views
189
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

The CMF Watch 3 Pro really impressed me with its price-to-quality ratio — to the point where the perceived quality often feels higher than its price.

This model is a mix of two existing designs:

I combined them into a single dock specifically adapted for mounting on an IKEA SKADIS pegboard. While integrating the SKADIS mount, special attention was paid to preserving the original fillet radii and overall geometry, ensuring the final model remains visually and structurally consistent with the original charging dock.

The dock holds the watch securely at the intended angle, maintaining the original proportions and shape defined by the base model. Structural adjustments were made only where necessary to support wall mounting.

Print settings

Seam position
  • Back

Infill
  • Pattern: Gradual TPMS-FK

  • Start density: 1%

  • End density: 99%

  • Gradual direction: Y-axis

This infill setup allows:

  • a strong and rigid rear section and mounting area suitable for SKADIS

  • a lighter but sufficiently strong front section, even though it is cantilevered

Supports
  • Strong tree support on build plate is mandatory

The model will not print correctly without supports.

Tags