Olympus C-5050 compact arca tripod plate
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Low profile arca type tripod plate and bottom right strap connector for Olympus C-5050 Zoom
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 39
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
About the design
This is a very compact arca-type tripod plate and bottom strap connector designed to fit the Olympus C-5050 zoom.
Note - I have an alternative version of this now, which is a bit thinner, has a bit wider base, and a more lozenge-y shape.
Printing it
I recommend slicing it top side down, with a lot of supports, since the steep angle on the left side will come out better that way - but with PLA it should be fine bottom side down too.
Attaching it
I've tested it with these screws: https://www.mcmaster.com/92220A181/
and there is an image attached with the specifications, since that's about as big as it can fit in terms of head width and height.
Just get a 1/4 20 screw that is about 1/4" long, with a head no wider than 0.375".
⚠ Disclaimer! Use at your own risk!
I have been using 3d printed tripod plate + strap connector combos for years with no problems, but ultimately the safety of your gear is up to you, and I take no responsibility for any damages caused if your copy of this design breaks or does not work with your gear.