1 / 6
IKEA BILRESA Tabletop Housing for Dual Button & Scroll Wheel Remotes — zdjęcie 1
1 / 6

IKEA BILRESA Tabletop Housing for Dual Button & Scroll Wheel Remotes

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Compact tabletop housings for IKEA BILRESA Matter smart remote series switches. Support-free prints.

Ocena
4,667 / 5
Polubienia
25
Pobrania
181
Wydruki
3
Wyświetlenia
547
Oceny
3

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a simple, clean tabletop housing designed for the IKEA BILRESA smart Dual Button Remote (806.178.76) and the Scroll Wheel Remote (706.174.57). Since the BILRESA is a great affordable Matter-compatible button, I wanted a way to keep them organized on a desk or bedside table rather than just having them loose or stuck to a wall.

Dual-Button Housing: Available in Single or Double variations.

Scroll Wheel Housing: A custom-fit cradle designed specifically for the round BILRESA wheel. It provides a stable base so you can adjust brightness or volume with one hand without the remote sliding or wobbling.

The fit is designed to be snug enough to keep the switch in place during use, but allows for easy removal from the bottom if you need to access the pairing button or change the batteries. Add some non-slip pads to the bottom to stop it from sliding.

I have included two variations for each remote, in either a 30 or 45 degree angle. All variations have an ergonomic rear finger slot for handheld use.

Print Instructions

  • Supports: None required.

  • Layer Height: 0.2mm works perfectly and looks great.

  • Infill: 15% is plenty, but you can go higher if you want more "heft" on the table.

  • Material: PLA, PETG, or ASA should all work fine.

Examples shown are printed with using Eryone Galaxy PLA, Eryone Tri-Color PLA, and Overture Matte PLA.

*** 03-08-2026 - 45 Degree Model Revision and added Scroll Wheel Housing ***

Moved the access hole down 6mm on the 45 degree models to provide more room for non-slips pads on bottom.

Tagi