1 / 8
Roof Rack for Prusa Core One L (RR C1L) — zdjęcie 1
1 / 8

Roof Rack for Prusa Core One L (RR C1L)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Roof rack to allow things to be placed on the printer without putting stress on the glass.

Ocena
5 / 5
Polubienia
16
Pobrania
19
Wydruki
1
Wyświetlenia
344
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Open Community License v1

I used a wide, specially shaped T-shaped aluminum profile, but this can be made with any sufficiently rigid profile, such as a rectangular tube, square tube, U-shaped tube, or simple T-shaped tube.

You will find the STLs for:

  • T-shaped wide: 11.5x31.5x1.5 mm (from Alfer Aluminum)

  • T-shaped simple: 15x15x1.5 mm

  • Square-shaped: 15x15 mm

  • Round-shaped: 14 mm

If needed, you will also find a STEP file to adapt or create the support to your own profile.

⚠There is a tolerance in the dimensions of the profiles. Dimensions may vary even from the same supplier.

Printing:

  • The supports must be placed with their largest surface area facing down on the build plate, as shown in the attached G-code file (Nozzle wiping included on the right side of the plate).

  • I printed using PETG without supports, with 4 perimeters and 20% infill. Medium hard TPU could be a good alternative.

Construction & Assembly:

  • The profile tube (rail) should be cut to a length of 44.5 mm.
    💡Remember to carefully de-burr the cut edges of your rails into a slight V-shape with a suitable file before inserting them into the supports.

  • Then you must drill holes in each rail end with a 3 mm drill bit at the appropriate points, depending on the support type.
    💡You can use the supports to mark the drilling points, the rail must be flush with the largest surface of the support.
    💡Don't forget to de-burr each side of the holes drilled in your rails with a canonical burr.
    💡You can tap the holes in each support with an M3 tap to facilitate screwing.

  • Then, slide a support onto the end of each rail cut and drilled, so that each end of the rail is flush with the largest surface area of each support.

  • To attach each support to a rail and create a Roof Rack, you will need one or two M3x22 or M3x20 screws.
    💡It is not necessary to over-tighten them; they are only there to prevent slippage.

  • In the case of the SpacePiX4 filament dryer support, I built two Roof Racks, meaning two rails and four brackets (supports).
    The empty weight of this dryer is 5 kg, so around up to 9 kg fully loaded.

⚠WARNING⚠:

  • This mod is not designed to support heavy loads, just like the Prusa Core One L's chassis.

  • It's use is entirely at your own risk.


Definitely better than that piece of plywood ... but the piece of plywood can now fit above ;-)

Can certainly be adapted for PRUSA Core One and One +

If you place a filament dryer on it, have a look at:



📢 Full plastic version available !

Tagi