1 / 8
Roof Rack for Prusa Core One L (RR C1L) — image 1
1 / 8

Roof Rack for Prusa Core One L (RR C1L)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Roof rack to allow things to be placed on the printer without putting stress on the glass.

Rating
5 / 5
Likes
16
Downloads
20
Makes
1
Views
353
Reviews
1

Updated at source:

Model information

Category
Accessories
License
Open Community License v1

I used a wide, specially shaped T-shaped aluminum profile, but this can be made with any sufficiently rigid profile, such as a rectangular tube, square tube, U-shaped tube, or simple T-shaped tube.

You will find the STLs for:

  • T-shaped wide: 11.5x31.5x1.5 mm (from Alfer Aluminum)

  • T-shaped simple: 15x15x1.5 mm

  • Square-shaped: 15x15 mm

  • Round-shaped: 14 mm

If needed, you will also find a STEP file to adapt or create the support to your own profile.

⚠There is a tolerance in the dimensions of the profiles. Dimensions may vary even from the same supplier.

Printing:

  • The supports must be placed with their largest surface area facing down on the build plate, as shown in the attached G-code file (Nozzle wiping included on the right side of the plate).

  • I printed using PETG without supports, with 4 perimeters and 20% infill. Medium hard TPU could be a good alternative.

Construction & Assembly:

  • The profile tube (rail) should be cut to a length of 44.5 mm.
    💡Remember to carefully de-burr the cut edges of your rails into a slight V-shape with a suitable file before inserting them into the supports.

  • Then you must drill holes in each rail end with a 3 mm drill bit at the appropriate points, depending on the support type.
    💡You can use the supports to mark the drilling points, the rail must be flush with the largest surface of the support.
    💡Don't forget to de-burr each side of the holes drilled in your rails with a canonical burr.
    💡You can tap the holes in each support with an M3 tap to facilitate screwing.

  • Then, slide a support onto the end of each rail cut and drilled, so that each end of the rail is flush with the largest surface area of each support.

  • To attach each support to a rail and create a Roof Rack, you will need one or two M3x22 or M3x20 screws.
    💡It is not necessary to over-tighten them; they are only there to prevent slippage.

  • In the case of the SpacePiX4 filament dryer support, I built two Roof Racks, meaning two rails and four brackets (supports).
    The empty weight of this dryer is 5 kg, so around up to 9 kg fully loaded.

⚠WARNING⚠:

  • This mod is not designed to support heavy loads, just like the Prusa Core One L's chassis.

  • It's use is entirely at your own risk.


Definitely better than that piece of plywood ... but the piece of plywood can now fit above ;-)

Can certainly be adapted for PRUSA Core One and One +

If you place a filament dryer on it, have a look at:



📢 Full plastic version available !

Tags