IKEA FÖRNUFTIG Housing for Particle and Gas Filter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An easy to print housing for the IKEA FÖRNUFTIG particle and gas filters
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 74
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
My motivation for designing this model was to add filtration (partical and gas) to my DIY wooden enclosure/shelf of my printer. The existing housing on printables (at this time) didn't fit my needs. So I decided to model a new one for my needs using FreeCAD.
After a lot of thinking about problems & their solutions and modeling in FreeCAD, I finally got my first good-enough version of this model. The print itself went well and the assembly worked as intended.
Dimensions:
HEPA Filter aka Particle Filter: 250 x 390 x 20 mm
Active Carbon Filter aka Gas Filter: 233 x 371 x 15 mm
Fan: 140 x 140 x 27 mm (Arctic P14 Pro PST)
v1
Tolerance at sides used for the particle filter: 0.4 mm
Tolerance at sides used for the gas filter: 0.4 mm
Thickness: 1.6 mm
v2
Tolerance at sides used for the particle filter: 2.0 mm
Tolerance at height used for the particle filter: 0.6 mm
Tolerance at sides used for the gas filter: 2.0 mm
Tolerance at height used for the gas filter: 0.6 mm
Thickness: 1.6 mm