Tripp Trapp Trofast Box Support
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bottom support for Trofast box in Tripp Trapp chair. Prevents tipping without clips or slides.
- Ocena
- 5 / 5
- Polubienia
- 4
- Pobrania
- 28
- Wydruki
- 1
- Wyświetlenia
- 177
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Does the Trofast box rails feel too tight? try my design instea dwhich only supports them from the bottom!
This is a simple bottom support designed to stabilize a Trofast box used in a Tripp Trapp chair. In my setup, the Trofast drawer partially enters the footrest recesses of the Tripp Trapp, which can cause it to tilt forward or slide out unintentionally.
Instead of using clip-based slide systems, this part supports the box from underneath, preventing tipping while keeping installation simple and clean.
In my case, no additional clips were needed. This may be because I sanded off the paint on my chair, which slightly changed the internal dimensions and improved the fit. Your results may vary depending on finish thickness and tolerances.
The design is minimal, strong, and prints without supports.
Key Features
Prevents Trofast box from tipping or sliding forward
Supports drawer from underneath
No clips or rails required
Simple, clean solution
Fully 3D printable
Prints without supports
Print Settings
Material: PLA, PETG, or similar
Infill: 20–30%
Supports: Not required
Print orientation: As provided
Notes
Fit may vary depending on paint thickness or chair production tolerances
If your chair still feels loose, clip-based solutions may be preferable
Designed for practical household use
Disclaimer
Always supervise children. This design is intended as a stability aid only. Muffelkraft assumes no responsibility for improper installation or misuse.