1 / 5
Traxxas Slash 1:10 Battery holder-LCG chassis — zdjęcie 1
1 / 5

Traxxas Slash 1:10 Battery holder-LCG chassis

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Improved battery holder for Traxxas Slash 1:10.

Ocena
0 / 5
Polubienia
10
Pobrania
45
Wydruki
0
Wyświetlenia
207
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial

Battery strap holder

Battery mount designed for the Traxxas Slash 4x4 1:10 LCG chassis (part no. 7422). The internal battery compartment measures 156 × 47 mm. I wasn’t satisfied with the stock battery mount because I use several packs of different sizes. This design solved the issue and made battery change much more convenient.

  • Tested from PET-G in temps below zero and in hot summer above 30°C.

  • Print with supports.

  • Insert the longer strap first, then attach the shorter straps, and finally mount the assembly into the chassis.

Hardware needed

  • Approximately 1 m of hook‑and‑loop strap (maximum width 15 mm). I’m using one 50 cm strap and two 22 cm straps.

  • Four M3×15 or M3×20 screws. The design is prepared for use with nuts, but I didn’t need them. If you choose to use nuts, make sure to use longer screws.

Tagi