Traxxas Slash 1:10 Battery holder-LCG chassis
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial
Battery strap holder
Battery mount designed for the Traxxas Slash 4x4 1:10 LCG chassis (part no. 7422). The internal battery compartment measures 156 × 47 mm. I wasn’t satisfied with the stock battery mount because I use several packs of different sizes. This design solved the issue and made battery change much more convenient.
Tested from PET-G in temps below zero and in hot summer above 30°C.
Print with supports.
Insert the longer strap first, then attach the shorter straps, and finally mount the assembly into the chassis.
Hardware needed
Approximately 1 m of hook‑and‑loop strap (maximum width 15 mm). I’m using one 50 cm strap and two 22 cm straps.
Four M3×15 or M3×20 screws. The design is prepared for use with nuts, but I didn’t need them. If you choose to use nuts, make sure to use longer screws.