Replacement Latch for Dewalt Wet/Dry Shop Vacuum DXV09P
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement latch for dewalt 9 gallon shop vac
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 51
- Wydruki
- 0
- Wyświetlenia
- 209
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Garage
- Licencja
- Creative Commons — Attribution — Noncommercial
I've had my vacuum a while now and with the cold, one of the clips finally broke. The factory ones are very sloppy and loose anyway. The one I made is shortened in height slightly to avoid accidental catching on things and reinforced in several areas. The outside is also made a little thicker, as that is the main weak point of the model. It's also important to orient the print on its side. There's a small protrusion on the side faces that is part of the locking mechanism, which makes you have to print support under the whole face to start the model. But this is not really seen anyway once it's on the vacuum.
Print Settings:
Orientation-Side (Printing on the bottom makes the layer lines a major weak point)
Filament-PETG
layer height-0.2
wall loops-6
Infill-85%
I used tree supports, they were easier to remove. If you use tree supports definately increase the density of the top interface to make your first faceof the print easiest since it's a large face.