1 / 1
Roxon 2slot short 4mm bit holder,- no magnets — zdjęcie 1

Roxon 2slot short 4mm bit holder,- no magnets

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Note I don't overly recommend this version; it is designed to use magnetic retention, without it needs tight tolerances.

Ocena
0 / 5
Polubienia
1
Pobrania
12
Wydruki
0
Wyświetlenia
107
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial

A remix of my previous design for people who do not intend to use magnets.

I don't particularly recommend this version; The original model is designed to use magnetic retention primarily to hold bits in place. Without that, the model will only work if your printer has very accurate tolerances and is using fairly strong/rigid filament!!!

I highly recommend using PC for this print!!! Other filaments may work, but PETG is liable to be too flexible and let the bits fall out, ABS/ASA risk tolerance issues due to shrinkage and will potentially be too brittle, and PLA is liable to not have enough strength or wear-resistance to hold up to repeated use. Your mileage may vary, but particularly don't complain if you ignore my advice and it gives issues.

Considering selectively using thin/dense "fuzzy skin" on parts of the model, particularly towards the end of the hex slot, to improve bit retention.

Tagi