CORE ONE + MMU3 chamber vent enclosed version automatic upgrade
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
MMU3 enclosed Version automatic vent upgrade for the blop version of the top cover V10 Firmware 6.5.3+12780
- Ocena
- 4,5 / 5
- Polubienia
- 13
- Pobrania
- 52
- Wydruki
- 2
- Wyświetlenia
- 303
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Update: works with Firmware Version 6.5.3, my impression is the autovent works a little smoother now.
The testfile has to be renamed to .gcode and works for the CoreOne+ but is your own responsibility.
The stock top cover of the enclosed version of the mmu3 with the blop has different vent openings like the acryl version. So i had to design a new Version of the slide stick. I used a test program to open and close the grille and it seems to work perfectly. You have to add the printhead mod from the CoreOne+ upgrade at Prusa printable parts. You can use the stock screws and the -ugly- knobs on the outside. Then you activate it in the hardware section of settings menu by turning it to ‚auto‘. Best prints in 30% infill gyroid with black Prusament PC-Blend (looks like the grille)
BUT: this is not an official Prusa part so i'm not responsible for any harm to your printer so here is the DISCLAIMER: if you using this mod it is your responsibilty anything fits together. Also you are responsible for start and end g-code mods and any damage there might occur.
If you want to fix the problem that the firmware doesn' t put the vent in the right position at every start here is a solution from the forum: