Shower Glass Door Self-Closing Pin Spacer - 2 mm (5/64") to 6 mm (1/4") Height Options
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Glass shower door pin spacer 2 mm (5/64") to 6 mm (1/4") to restore clearance and self-closing function.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 84
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution
This spacer was designed to fix a common issue with glass shower doors that use a self-closing pin mechanism with a plastic cam component.
Over time or due to installation tolerances, the glass door may sit slightly lower and start touching the floor. When this happens, the self-closing mechanism no longer works properly because the door cannot move freely.
This 3D-printable spacer lifts the door slightly, restoring proper clearance and allowing the self-closing system to function as intended.
The model is available in multiple height variations to accommodate different gap requirements.
Available Sizes
The spacer is available in the following heights:
2 mm (0.079 in ≈ 5/64")
3 mm (0.118 in ≈ 1/8")
4 mm (0.157 in ≈ 5/32") – the version currently installed in my shower
5 mm (0.197 in ≈ 13/64")
6 mm (0.236 in ≈ 1/4")
Choose the height that best restores proper door clearance without creating excessive vertical play.
Printing Recommendations
Material: PLA (tested and working well in a bathroom environment)
Layer height: 0.16 mm recommended
Infill: 80% for maximum strength and durability
Supports: Not required
Orientation: Print flat on the build plate
Brim: Optional, depending on bed adhesion
Since this part supports the door’s pivot mechanism, I recommend printing with high infill and good layer adhesion to ensure long-term durability.
Installation Notes
Remove the glass door carefully.
Insert the spacer into the pin mechanism where the plastic cam component sits.
Reinstall the door and test movement.
Ensure the door swings freely and that the self-closing function operates correctly.
⚠ Always handle glass with care during removal and installation.
Why I Created This
In my case, the glass was slightly touching the floor, preventing the door from closing automatically. After installing the 4 mm (0.157 in ≈ 5/32") spacer, the mechanism worked perfectly again.
Instead of adjusting the entire door structure, this small spacer provides a simple and precise solution.