Handguards for Kawasaki Z750S
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
These guards are made to fit the bike and create sufficient wind protection. They only provide WIND protection.
- Ocena
- 4 / 5
- Polubienia
- 42
- Pobrania
- 329
- Wydruki
- 1
- Wyświetlenia
- 2384
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
Hi everyone.
I share here my solution to provide some wind protection for the Kawasaki Z750S. As you may have already found out if you arrive here, getting handguards it's difficult, most of them don't fit properly. And if you are like me and like to ride as much as possible, wind protection and hand warmers are more than welcome.
I recommend adding extra perimeters, 5 or 6 is the best. Infill in general does not help that much, 20% is enough.
I printed it in PLA because I found it in the same color as the bike, but in theory, PETG should perform better.
I also turned the head of some stainless steel screws, just because the old ones looked a bit rusted already. But the original ones should be long enough.
I hope someone finds this usefull.