1 / 16
FMS Futura 64 EDF Belly-Landing Servo Horn Covers – Lightweight Aerodynamic Shrouds — zdjęcie 1
1 / 16

FMS Futura 64 EDF Belly-Landing Servo Horn Covers – Lightweight Aerodynamic Shrouds

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

These lightweight aerodynamic shrouds to protect the exposed aileron and flap servo horns on the FMS Futura 64

Ocena
5 / 5
Polubienia
3
Pobrania
67
Wydruki
1
Wyświetlenia
213
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This part fits the underside of the wing on the FMS Futura 64 EDF and covers the exposed aileron and flap servo horns when the landing gear is removed for belly landing configuration. I've also added a matching front skid for those who want one.

Do me a favour and ‘like’ this print if you find it useful.

The Shrouds

• Protect servo horns during belly landings

• Improve aerodynamic smoothness compared to exposed horns

• Add minimal weight

• Maintain access to servos if screw-mounted

Switching from the stock fixed undercarriage to belly landing with streamlined servo horn fairings reduces parasite drag and improves aerodynamic efficiency. The original landing gear creates significant drag because the wheels and struts act as bluff bodies in the airflow. Removing the gear cleans up the underside of the aircraft and can help improve potential top speed. When converting to hand launch and belly landing, the servo horns and pushrods become exposed and vulnerable. These fairings cover the linkage with a smooth streamlined shape, reducing turbulence while also protecting the servo horns during belly landings.

The walls are approximately 1 mm thick, creating a rigid shell without unnecessary mass. If needed, the base of the part can be warmed (eg on the printer bed) and shaped to any uneven surfaces on the wing.

Mounting Options

Option 1 – Glue (Wont Move)

• Clean the wing surface

• Remove stickers where bonding is required

• Ensure direct foam-to-part contact

• Use foam-safe adhesive

• Hold in place until cured

Option 2 – Removable Screw Mount

• Mark screw hole locations

• Drill shallow (10mm) pilot holes into the foam ( go easy, use drill in reverse turn)

• Fill pilot holes with resin to create a hardened anchor

• Allow resin to fully cure, and before fully set push on the top to flatten the surface of the resin

• Re-drill pilot holes into cured resin

• Install screws (M2) through the cover into the reinforced holes

This allows ongoing access to servos.

Always check CG after removing landing gear and modifying servo configuration.

Recommended Settings

Layer Height: 0.12 mm

Infill: 100%

Wall Thickness: 1 mm design thickness

Supports: Enabled

Material: PLA or PETG

Small layer heights improve strength and surface finish.

Print with the flat base on the build plate.

Supports are recommended under the curved top and rear transition.

if you are interested in speed, check out this modification - 

Tagi