CORE One L INDX / MMU3 Extruder cable anti sag solution. Only Tywrap needed!
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Prusa CORE One L extruder cable sag prevention
- Ocena
- 0 / 5
- Polubienia
- 31
- Pobrania
- 45
- Wydruki
- 0
- Wyświetlenia
- 1211
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Since the Extruder cable bundle is already sagging on the CORE One L i think it will need support with an MMU3 / INDX conversion. (Users reporting of the cable bundle got stuck behind an rear fan as it is.)
Because my previous CORE One anti sag ty-wrap mod was quite populair i converted it to the CORE One L.
It involves the removal of original PTFE tube (store for future use or when u remove MMU / INDX altogether)
The cable clips on the outer floating clamps are bigger. Because the CORE One L travels a lot of X - Y the cable has to go freely in it so it can slide a little. (After an small bend i would bulge without being able to slide)
Another problem is that because of this cable bending in the corners you cannot run the Ty-wrap completely to the extrduer head like in the CORE One model.
Why screws this time? I tried a lot of things but the clips just kept moving.
You only need an "common" Tywrap 9mm wide (2mm thick) cut 31 cm long.
And 4x m3x8 (swingarm mounts) and 2x m3x6 screws (floating mounts)
Print in PETG for heat resistance and flexibility.