Silverstone RVZ03 Case Mods
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
More air flow, better GPU support, and feet
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 48
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Public Domain
Top/Bottom Panel (Triple Fan Mount)
Add three 7010mm fans to the top/bottom panel of the case for dramatically improved airflow and thermals. This custom-designed mount integrates cleanly with the existing case geometry and supports intake or exhaust configurations. I have added 4 slots for 10x2mm magnets
PLA, PETG, ASA, or ABS
Fits: 3x 7010mm fans
Print settings: 0.2mm layer height( or smaller, I used .16mm), 4 walls, 10% infill, built-in supports, no slicer supports needed, supports (unless you use PETG)
Panel Tabs Standard/Long
Had to make these slot-in instead of printing them all on the panel, you will need 4 Standard pins and 2 long pins
PETG, ASA, or ABS (any filament that will not snap when bent slightly)
Print settings: 0.2mm layer height( or smaller), 4 walls, and 10% infill
Silverstone RVZ03 – Reinforced GPU Mounting Bracket
The stock RVZ03 GPU Mount bracket leaves the end of your graphics card hanging unsupported — this redesigned bracket fixes that. Extended support along the full length of the GPU prevents sag and PCIe slot stress. I have added cable tie downs for PCIe power cables. You do lose two 2.5 drive cages
ASA, ABS, or PETG (A plastic that can handle GPU temps)
Used 2x m3 nuts, 2x M3x8 SCHS and, 2x M3x20 SCHS
3x M3x4 Heatset Insert 3x M3x5 SCHS
Print settings: 0.2mm layer height( or smaller, I used .16mm), 4 walls, 10% infill
Silverstone RVZ03 – Custom Case Feet
Fresh feet for the RVZ03 that improve ground clearance for better bottom-panel airflow. Designed to match the case's aesthetic.
TPU
Print settings: 0.2mm layer height, 5 walls, 70% infill
Silverstone RVZ03 – Power Plug Extension / Relocator
Running a 2.75 slot GPU in the RVZ03? The stock power inlet placement can block thicker cards from fitting. This extension relocates the plug connection to clear the way, allowing you to push GPU compatibility to the limit without cutting or modifying the case.
2x M3x40 screws 2 M3 Nuts
PLA, PETG, ASA, or ABS
Print settings: 0.2mm layer height, 4 walls, 20% infill