Telepass bracket (correct print orientation)

I tried a bunch of other models here on Printables, but all expect you to print them in one piece, standing upright, meaning the blade of the bracket is in the weakest orientation possible, at risk of breaking... or worse breaking inside the device.

I took a little time designing this two pieces alternative so that the blade is printed flat, in its strong orientation, and held to the base, also printed flat, by two M3x8 screws.

This has the added benefit that if the blade degrades you can reprint just that and not bother with the part which will remain glued to the windshield.

Print in PETG or ABS, since it will vet toasty in the car.

There is a tiny bridging where the device will "click" on the blade. If you notice some irregularity or a bit of sagging, clean it up with an xacto knife or similar, or it may be difficult to remove the device after it clicks.