Sunlu S4 Dryer Filamentalist FV3 Rewinder Feet for Front & Rear/Centre Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Sunlu S4 Dryer Filamentalist FV3 Rewinder Feet for Front & Rear and Centre Mount, centre pass through hole for PTFE tube
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 492
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- GNU General Public License v3.0
This model is used as a base/feet for the FV3 Rewinder (https://github.com/Carrot-collective/Filamentalist_Rewinder/tree/main/Filamentalist_FV3_Rewinder) inside Sunlu S4 filament dryer.
====== Update 2026/03/25 ======
Based on the above changes, I have made further changes so that the feet can be used for FV3 centre mount (https://github.com/Carrot-collective/ERCF_v2/tree/master/Recommended_Options/Filamentalist_Rewinder/Filamentalist_FV3_Rewinder/Stls/Chassis/Standalone_Mount_Assy/Center_Mount_Version)
In my personal experience, I think the centre mount version has a lower feeding friction comparing to the front & rear, regardless the usage of the side or the top outlet of Sunlu S4 dryer. Because the centre mount already has the pass through, with the centre mount feet, you'll notice the PTFE has a very shallow angle and it is less bended. (please see the pictures, the blue version is the centre mount version).


======
The original model's screw hole does not align with the front & rear mount (https://github.com/Carrot-collective/Filamentalist_Rewinder/tree/main/Filamentalist_FV3_Rewinder/Stls/Chassis/Standalone_Mount_Assy/Front_Rear_Mount_Version) and it also does not leave the pass through for PTFE, it would become a bit inconvenient if you choose to use a bottom load configuration on your FV3 rewinder (front v.s. bottom load, see the image below)

So this model solves these 2 pain points I have:
screw mounts for front & rear mount
PTFE pass through for bottom load configuration
I use this model (https://www.printables.com/model/1065535-s4-dryer-extender-for-filamentalist-install to create enough clearance for FV3 in Sunlu S4. And this feet will allow me to feed the filament without bending the PTFE tube too much.
