Roborock Saros hair-cutting/tricut brush adapter/conversion kit for Qrevo vacuum bots
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Parts to retrofit the hairs cutting brush of the Roborock Saros Z70 on the previous generations bot (QRevo at least)
- Ocena
- 5 / 5
- Polubienia
- 1
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 424
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
I was pretty sad that the hairs cutting brush of the Roborock Saros Z70 wasn't retrofittable on the previous generations. People at home have quite long hairs and the brush of my bot Chaussette (Qrevo MaxV), that I have since one year and half approximately, was struggling with it. I had tried previously to retrofi the Dreame Tricut brush on it without succes (to long to, big diameter to heavy, even with the intervention of a file). So now that Roborock has acces to the same technology but didn't made it old gen compatible I took my caliper and tried again to make a conversion.
To use it you firstly need to unscrew the plates on each side of the Saros brush. Remove gently the head of the screw side with a flat screwdriver and remove the bearing with a hammer and a nail for exemple (without damaging it). You can then assemble the parts of the kit on the Saros brush. Use the rings of the Qrevo brush to finish the assembly (it is important to protect the motor and the screw mecanism from dust and from hairs tangling).
I printed it on a Snapmaker U1 with PLA and a layer height of 0.1 mm. I will also probably try on a Prusa MK3S when I will have the time. (Don't forget to add some grease :) on the screw mecanism and maybe a little bit of fine oil on the cutting combs).
After some wandering, everything seems to work fine, but the brush is a little bit noisier. Hope your bot will be happy with it :).
P.S.: (If needed I also put an earlier version, V2, of the motor side adapter which use a M3 screw and doesn't use the original Qrevo brush. This version is more permissive on the tolerancing aspect by giving more axiale clearance between the rings faces on the brush and the shoulders faces on the robot parts).