SV08 Top Hat 220mm Magnets

I did some changed some things from the original model, mostly for static reasons and also to reduce the amount of different parts.

• Use of 6×3 mm magnets instead of 5×3 mm.

• Standardization of parts so that fewer different components need to be printed.

• The cable entry was moved to the back; in the original model it would have been on the side.

• The cable entry was separated into its own part, allowing it to be omitted or modified.

• The outer design with the 3D-printer-style grooves was retained.

• The overall fit was revised and improved.

• The through screws were replaced with heat-set inserts and screws only from inside.

BOM:

• 64 x Brass heat-set threaded insert M3x4x5mm

• 50 x M3x8mm flat head socket screw

• 4 x M3x25mm hex socket head cap screws

• 4 x M3x30mm hex socket head cap screws

• 4 x M3x35mm hex socket head cap screws

• 20 x Magnet 6x3mm

• Superglue