Mounting Block for Victron SmartShunt
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This mounts the shunt on a thin walled case.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 96
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Public Domain
This block is a back plate for mounting a Victron Smartshunt on an enclosure. The block is placed on the outer surface of the enclosure to provides both security and stability. Drill 2 holes 100mm apart and place the shunt inside. The bolts go through the shunt mounting holes, the enclosure holes, and thread into nuts inside the mounting block. The mounting nuts are placed inside the block prevent tampering from outside of the enclosure. I printed this with 35% infill and 3 perimeters. The mounting nuts measure 3.15x9.25 mm (flat to flat); 3.15x11mm (point to point). The fit is tight. The mounting holes measure 7mm diameter. I used an SAE 10/24 bolt 25mm (1") long. An f3d parametric model is available for adjustments.