Bang & Olufsen Beolab 2500 wood front bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Brackets to add wooden fronts to the Bang & Olufsen Beolab 2500 speakers
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 122
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution
Description
While restoring my Beocenter 2500, I wanted to replace the original Beolab speaker fronts with wooden slats for a warmer, more natural look. To achieve this, I designed a 3D-printed PETG bracket that attaches to the original fronts using double-sided tape.
The bracket holds the wooden slats in place by clamping them, so no adhesive is required for most of the slats. This also means the wood can be removed or replaced later if needed.
Only the outer slats are not clamped by the bracket, so I fixed those with a small amount of adhesive.
This design was made for the speakers of the Bang & Olufsen Beolab 2500, which are typically paired with the Bang & Olufsen Beocenter 2500.
Materials
For one pair of speakers you will need:
38 wooden strips
Dimensions: 18 × 4 × 330 mm
These dimensions fit perfectly within the clamp system of the bracket.
Assembly
Attach the printed brackets to the original speaker front using double-sided tape.
Insert the wooden slats into the bracket so they are clamped in place.
Apply adhesive only to the outer slats, as they are not held by the clamp.
Repeat for the second speaker.
Each speaker uses 3 brackets, as shown in the photos.
Printing
Recommended material: PETG
Print orientation: flat on the build plate
No special print settings required