Baofeng UV 5RH PRO, UV 5RM Battery adapter for 18650
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Battery adapter for the baofeng UV-5RH PRO, it use 2x18650 batteries insted of the original one.
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 51
- Wydruki
- 0
- Wyświetlenia
- 373
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a custom battery adapter for the Baofeng UV-5RH PRO. It allows you to power your radio using two 18650 Li-ion batteries instead of the original battery.
I recomend printing it in PETG or ABS for better durability compare with PLA
Materials:
4x M2x10mm
2x M2x4mm (Note: You might need to trim these slightly shorter than 4mm for a perfect fit).
Wiring: A few centimeters of thin copper wire for internal connections.
Contacts: For the metal connectors, I made them using streaps of metal from a tuna can. You can use any conductive spring steel or copper tabs you have on hand.
Installation:
Bottom Section: Clamp the wires using the screws, ensuring a solid contact with the metal strips.
Top Section: Repeat the same process. Pass the wire through the hole, guide it through the internal channel, and secure it with the screw while ensuring contact with the metal strip.
Important: Be careful with the length of the screws. If the screw protrudes too far from the surface, it may damage the radio's connectors. Trim them if necessary.
You may need to secure the battery adapter with a zip tie in the bottom, as shown in the imagen.
This is a DIY project involving lithium batteries and electronic equipment. Use this adapter at your own risk. I am not responsible for any damage to your radio, batteries, or personal property caused by improper assembly, polarity reversal, or misuse of this adapter. Always verify your voltages and connections with a multimeter before connecting it to your Baofeng.