1 / 3
Snap-Into-Place Fin Mechanism (Proof-of-Concept) — zdjęcie 1
1 / 3

Snap-Into-Place Fin Mechanism (Proof-of-Concept)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Prototype/proof-of-concept of a mechanism to snap second-stage rocket fins into place upon initial separation.

Ocena
0 / 5
Polubienia
1
Pobrania
2
Wydruki
0
Wyświetlenia
59
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Engineering
Licencja
Creative Commons — Public Domain

This is a large-scale prototype of a mechanism to snap the second stage fins of a 2-stage rocket into place after separation of the stages. 

The idea is: 

Two torsion springs (one on either side of the fin) are used to fold and store the fin in the body tube until the first separation event that is triggered from the first stage motor ejection charge. Once the separation event is triggered and the second stage (what the folding fins are attached to) pulls out the folding fins, the stored potential energy in the springs cause the fin(s) to snap into place from the horizontal position to the vertical position.

This mechanism would allow for the removal of the second stage fins from the outside of the body tube during the burn of the 1st-stage motor. This leads to significant aerodynamic performance improvements --> reduces drag --> leads to higher apogee being reached.

Another thing to notice about the design is how the two sides at the bottom of the fin are not the same. One side has a rounded corner, while the other has a fully square corner. This helps to allow rotation in only one direction. This is important since the fins would experience a significant amount of drag after deployment. We want to prevent the drag from over-rotating and pushing the fins back into the folded position (rendering them near-useless).

After printing the parts out, assembling them, and testing the mechanism out, it works just as I imagined it would. That is good. Now work can be put into scaling the mechanism down to the point where I can actually fit in the body tube of the rocket my group has designed. 

And to conclude, I would like to restate, this is just a prototype/proof-of-concept. I'm certain many improvements could be made. I will be on a quest to find them. If anyone has any tips/suggestions, I would love to hear them!

* This is part of an undergrad aerospace engineering senior capstone project being done at UCLA.

Tagi