Nucleo F446RE Case with Press-Fit Lid – v1
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Two-part enclosure for Nucleo-64 F446RE. Press-fit lid. Cutouts for USB, buttons, Morpho headers CN7–CN10, LED windows
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 109
- Wydruki
- 0
- Wyświetlenia
- 326
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
A clean two-part enclosure for the STM32 Nucleo-64 F446RE development board. The lid attaches with a press-fit — no screws or glue required.
Designed cutouts:
USB port (CN1) for cable access
User buttons B1 and B2
Morpho headers CN7, CN8, CN9, and CN10 (fully exposed)
Three small holes for the onboard LEDs (LD1, LD2, LD3) so status is always visible
Print settings:
Material: PLA
Layer height: 0.2 mm
Infill: 20–30 %
Supports: not required
This is version 1. I plan to iterate based on fit and feedback — corrections and improvements will follow.
Feedback and remixes are very welcome!