DJI Phantom 3 Standard Phone Mount for contoller
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Phone-mount ball part, mounted on the railing of your good old DJI Phantom controller.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 102
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I have just acquired a second-hand DJI Phantom 3 standard; unfortunately, the phone holder mount was broken. I was looking all over the internet (with no success) to find that specific part with ball at the end, that holds the phone clip mount... Due to this remote being apparently so "old" there was no aftermarket parts available for that in my country and only option was buying used remote for 40$ (i paid 100$ for this drone with a dedicated backpack) which sounds mad. Even aliexpress didn't help much, i wasn't albe to find this part and every alternative mount was just too expensive. So there it is - to the best of my abilities, i have recreated the "ball joint" arm holder thingy.
What do you need:
2x M3 x 4mm heat inserts alternatively you can just use M3 nuts - requires much longer screws
2x M3 x 8 phillips screws I have also tried m3x10 but they stick out just a bit, i'd go with M3x8
Printing settings i recommend:
0.2mm layer height
4-6 walls
50% gyroid infill
Supports needed.
Print in the exact orientation of the model for the best strength. You will need supports at least for the ball part; the angle and holes should be handled easily with modern printers
Of course we all know, this should be printed in PET-G.. Unless you don't have a white PET-G laying around like I do, will see how PLA handles that :P