Simplified Spray Bottle Holder for Honeycomb Storage Wall!
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
HSW Spray Bottle Holder remixed for faster and stronger printing with an M3 screw to mount.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 80
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Remix of the Spray Bottle Holder by zhollis21 and Ellrico in an attempt to make it simpler to print and improve strength. I like the simplicity of the base design but was not fond of the snap-in honeycombs and how they complicated printing the object.
I decided to make this design more modular and require only a single M3 honeycomb insert and increased the rear wall thickness of the print to accommodate it. Afterwards, I realized it would be a great candidate for a 45 degree print angle so I cut the model so it would easily lay down at that angle.
Model shown is printed with Sunlu Matte Purple PLA and my temps were a bit high as you can see all the wisping. I printed 4/4/4 perimeters/top/bottom layers and it is FAR stronger than it needs to be.