Hinged Clamshell Case for Anex Offset Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Case that holds Anex offset wrench (AOA-19) and associated bits/adapters
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 50
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- GNU General Public License v3.0
Case to house an Anex Offset Driver, 1/2 drive adapter, 1/4 drive adapter, screwdriver bit adapter, short body bit adapter, and a small prybar.
This is a great tool, but couldn't find a case that held it and all the assorted pieces parts. So I drew one.
Each adapter has its own fitted space, and the wrench has a hollow underneath so it can be stored with most of the adapters installed (long bit adapter cannot be stored installed). Also holds the hex key for adjusting the short body bit adapter.
Other than the Anex goodies, it also holds a cheap amazon 'edc keychain prybar' to make tool disassembly / swap easier - I don't always have a flathead screwdriver around. Link here: https://a.co/d/099yUU7z
Hinges are 2x M3x70 bolts with square nuts, mostly because that's what was on hand. The hinge cavity for the bolt head is purposely a touch undersized. I didn't want it working out so it is designed as a heatset. Install the bolt until only the head is exposed, hit it with a soldering iron for 10-15 seconds, then finish screwing it in.
No supports needed, print each part with the case's largest exterior face down. I used PETG for temperature stability, PLA would work fine if you don't plan to take your toolbox outside in the summer (or forget it in your vehicle).
The F3D file is included so you can modify to suit your needs.
AOA-19: Offset Wrench
AOA-19AD4: 1/2 socket driver adapter
AOA-19AD3: 1/4 socket driver adapter
AOA-19BA: large body bit adapter
AOA-19BAS: small body bit adapter