Deutsch DT receptacle flange adapters for panel mounting
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Deutsch DT plugs/sockets are great, these models allows you to install them into panels/electronic enclosures easily.
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 204
- Wydruki
- 0
- Wyświetlenia
- 444
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
TBD soon: Upload pics of finished installation
I wanted to use DT plugs/sockets for an electronics enclosure. Flanged versions are available but not as common. Also, cutting square holes into panels sucks.
My version is meant to be installed using a holesaw.
NOTE: Model is already scaled for PETG Shrinkage (scaled by factor 1.0033).
Print instructions
PETG, 6 perimeters, 35% Infill, no supports, lay flat on front face
Materials needed (all models)
4x M4 screw
8x M4 washer
4x M4 nut
Drill (M4 through-hole, diam. ~4.3 mm)
1x Holesaw (22 mm for 2P/3P, 32 mm for all other versions)
opt.: thread-locking of your choice (Nylocs, Loctite, spring washers..)
opt.: O-ring if you want additional ingress protection (26x2 IDxCS for 2P and 3P model, 35x2 for all other versions)
Installation:
Drill central hole with holesaw
Deburr hole e.g. with sandpaper
(Opt.: install O-ring into model groove)
Press cylinder of model into hole
Use model corner hole as drilling template for first hole
Drop a screw into the first corner hole (to fix flange in place/prevent rotation)
Use model as drilling template for remaining 3 corner holes
Install M4 screws
Share pics if you made some pretty enclosures using this model ;)