Deutsch DT receptacle flange adapters for panel mounting
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Deutsch DT plugs/sockets are great, these models allows you to install them into panels/electronic enclosures easily.
- Rating
- 0 / 5
- Likes
- 15
- Downloads
- 220
- Makes
- 0
- Views
- 469
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
TBD soon: Upload pics of finished installation
I wanted to use DT plugs/sockets for an electronics enclosure. Flanged versions are available but not as common. Also, cutting square holes into panels sucks.
My version is meant to be installed using a holesaw.
NOTE: Model is already scaled for PETG Shrinkage (scaled by factor 1.0033).
Print instructions
PETG, 6 perimeters, 35% Infill, no supports, lay flat on front face
Materials needed (all models)
4x M4 screw
8x M4 washer
4x M4 nut
Drill (M4 through-hole, diam. ~4.3 mm)
1x Holesaw (22 mm for 2P/3P, 32 mm for all other versions)
opt.: thread-locking of your choice (Nylocs, Loctite, spring washers..)
opt.: O-ring if you want additional ingress protection (26x2 IDxCS for 2P and 3P model, 35x2 for all other versions)
Installation:
Drill central hole with holesaw
Deburr hole e.g. with sandpaper
(Opt.: install O-ring into model groove)
Press cylinder of model into hole
Use model corner hole as drilling template for first hole
Drop a screw into the first corner hole (to fix flange in place/prevent rotation)
Use model as drilling template for remaining 3 corner holes
Install M4 screws
Share pics if you made some pretty enclosures using this model ;)