1 / 2
Dual 40mm Axial fanduct for UE3V2 Toolhead — zdjęcie 1
1 / 2

Dual 40mm Axial fanduct for UE3V2 Toolhead

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

New fanducts for UE3V2 Toolhead. Takes 40mm axial fans. Includes BLTouch relocator.

Ocena
0 / 5
Polubienia
1
Pobrania
7
Wydruki
0
Wyświetlenia
93
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Update:
Version 2 now available, even better than the original!

Fanduct that takes 40mm axial fans and attaches them to the Ugly Ender3V2 Toolhead.
Includes a BLTouch mount because the original won't fit with these fanducts.

Holes that will take screws are 2.7mm so you can force thread or tap M3 threads in them. No need for nuts.

Fits both the original or my own little remix.

After experimenting with a lot of different duct designs for the original 5015 radial implementation and trying different 5015's, I came to the conclusion that radials plain suck when you really need to move air in bulk. Low backpressure ducts with axials move much more air and can cool prints way faster.

I've included Madau3D's Statorinator airflow guides, they help get maximum efficiency from axial fans that blow through ducts. Ofcourse, they're optional, but I recommend them. They are available for fans with 18mm and 24mm hub diameters.

Printing instructions:
Ducts and BLtouch mount are oriented as they go on the hot-end, not as they should be printed.
Most slicers should have a way to select the face that should touch the buildplate and then automatically rotate it correctly.

Print the ducts on their fan mounting flanges for optimal results and least use of supports.

Print the BLtouch fan bracket mount on the lower screw mounting points (tilted 90 degree back from STL) with regular supports (not tree/organic).

Mounting instructions:
Pre-forming threads is not necessary but does make final assembly easier. This can be done by just forcing an M3 bolt through. Heating the bolt with a flame/lighter makes it easier.
If you have an M3 thread tap, that would be the best.

The fanducts can be mounted to the hot-end with very short M3 screws. 6mm length is enough. This also goes for the BLtouch sensor. 
There's no need for nuts. Just M3 bolts/screws.

For the fans, bolt length will depend on the size of the fans. Usualy, 25 or 30mm is a good choice for thick 40mm fans.

Tagi