1 / 2
1/4" Socket Compact 8x Bit Holder (TPU)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holds 8 1/4" socket bits with an OD of roughly 12.15mm. This can be scaled up or down to fit yours.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 89
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
The bits can be pushed in by the square end and out by the male or female hex end to allow for easier removal. There is a very small break in period.
Print with TPU at 100% infill. No raft should be needed unless you have really bad adhesion.
Made this because the ones that come with a lot of these small sets are terrible and/or cumbersome.
If scaling, keep holes oval. It should be the diameter of your bit long ways, short ways the holes should be smaller. It will stretch - this is the intent.