1 / 2
1/4" Socket Compact 8x Bit Holder (TPU) — image 1
1 / 2

1/4" Socket Compact 8x Bit Holder (TPU)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Holds 8 1/4" socket bits with an OD of roughly 12.15mm. This can be scaled up or down to fit yours.

Rating
0 / 5
Likes
3
Downloads
10
Makes
0
Views
89
Reviews
0

Updated at source:

Model information

Category
Organizers
License
Creative Commons — Attribution — Share Alike

The bits can be pushed in by the square end and out by the male or female hex end to allow for easier removal. There is a very small break in period.

Print with TPU at 100% infill. No raft should be needed unless you have really bad adhesion.

Made this because the ones that come with a lot of these small sets are terrible and/or cumbersome.

If scaling, keep holes oval. It should be the diameter of your bit long ways, short ways the holes should be smaller. It will stretch - this is the intent.

Tags