Nebra LoRa Antenna Wall / Window Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a window or wall mount for the Nebra LoRa antennas, specifically tested with their 50cm long 5.8dbi antenna…
- Ocena
- 5 / 5
- Polubienia
- 20
- Pobrania
- 102
- Wydruki
- 1
- Wyświetlenia
- 1129
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
This is a window or wall mount for the Nebra LoRa antennas, specifically tested with their 50cm long 5.8dbi antenna that can be found here: https://www.nebra.com/products/glass-fiber-lora-antenna-peak-gain-5-8dbi/
The design has both screw holes and space on the back to mount 3M Command strips depending on your preferred method of mounting. The hole in the bottom allows the N type connector to fit through while not allowing the antenna to pass. The screw holes will fit a 5mm screw shaft and up to a 9mm head size. This mount should also fit any antenna that has a similar base width of about 23mm diameter. If you have any other antennas that fit, let me know so I can add them into the description.
For a larger version of this mount that has been tested to work with the 90cm long RAK and Sparkfun LoRa antennas, visit this page: https://www.thingiverse.com/thing:4931860
Print Settings
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
No
Resolution:
0.24mm
Infill:
30%
Filament: eSun PLA Silk Gold
Notes:
PETG or stronger recommended for extended use / for areas outside.
Category: Electronics