1 / 4
Modular Pegboard - 100% Parametric Design
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a simple strong pegboard/shelving system that is easily 3d printable or laser cuttable.
- Ocena
- 5 / 5
- Polubienia
- 248
- Pobrania
- 2382
- Wydruki
- 2
- Wyświetlenia
- 22 035
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- GNU Lesser General Public License
SzczegółyPliki (18)Wydruki i komentarze (Wydruki: 2) (Komentarze: 4)Remiksy (2)Kolekcje (377)Powiązane
Parameters:
- HoleSpacing - How far apart the center of each peg is. Default = 25mm
- PegHoleDiameter - The width and height of each square hole. Default = 5.5mm
- PegboardHeight - How tall the pegboard is, which dictates stiffness. Default = 5mm
- PegExtraWidth - Can use to make the pegs slightly wider in order to eliminate side to side movement. Default = 0.1mm
- NumberOfHolesInXDirection - How many holes wide the pegboard is. Default = 8
- NumberOfHolesInYDirection - The number of holes tall the pegboard is. Default = 8
- SnapConnectorTolerance - The spacing between the snap connector and the pegboard hole. Default = 0.3mm
- FastenerHoleDiameter - The diameter of the hole in the snap connector to nail the pegboard to the wall. Default = 3mm
- PegClearance - How much smaller the peg is than the hole so that it can slide in and out. Default = 0.42mm
Instructions:
Minimum viable print settings to minimize material use while remaining perfectly strong (about 80g per 200x200mm pegboard panel):
Bottom layers: 2
Top layers: 3
Infill: 15%
- Print ‘1x2 Pegboard .stl’ to test fits against.
- Print ‘1x1 Snap’ and ‘Peg.stl’.
- If for some reason the snap connector doesn't snap in or the peg doesn't fit in snugly, adjust SnapConnectorTolerance and PegClearance respectively.
- Repeat steps 2 and 3 until you get the fit juuuust right.
- If you had to change parameters, export new ‘1x1 Snap.stl’, ‘1x2 Snap.stl’, ‘2x2 Snap.stl’, ‘Peg.stl’, and 'SideWallSupportPeg.stl'. You do not have to re-export the pegboard sizes, unless you want a custom size I have not already exported.
- Print all the pegboard you heart desires!
Tips:
- You can mount pegboard horizontally to create a shelf, or vertically (perpendicular to the wall) to create more pegboard surface area with less wall space. The SideWallSupportPeg allows you to lock shelves or perpendicular vertical pegboard in place.
- Make the topmost and bottommost layer use the concentric pattern to create a nice looking surface.