1 / 3
DeepCool Gamer Storm cooler block to LGA1200 mounting bracket — zdjęcie 1
1 / 3

DeepCool Gamer Storm cooler block to LGA1200 mounting bracket

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Brackets for a DeepCool water cooler block to mount to an LGA1200 or any similar socket with 75mm x 75mm mount

Ocena
0 / 5
Polubienia
2
Pobrania
21
Wydruki
0
Wyświetlenia
86
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I picked up a DeepCool Gamer Storm cpu water cooler at the thrift shop that was missing the mounting brackets so I made these. I installed them and ensured proper alignment but unfortunately the water cooler didn't work, so I couldn't do any long term testing. 

The slots for the m3.5 nuts are slightly oversized. The nuts drop in easily but don't hold themselves in, so I would recommend attaching the brackets to the cooler first, then to the motherboard. I would tweak this to be a friction fit, but I dont want to sink any more time into this project.

Printed at 0.2mm layer height, tree supports, 15% infill, and triangles infill pattern. I also enabled ironing on all top surfaces, not necessary but I think it cleans up the part nicely. Here are the Ironing settings I used if you decide to do the same:

Ironing type: All top surfaces
Ironing pattern: Rectilinear
Ironing speed: 60mm/s
Ironing flow: 20%
Ironing line spacing: .15mm
Ironing angle: 90

Not sure how useful this model will be since this is an older water cooler, but it could be easily modified to fit other coolers. 

Tagi