1 / 3
Parkside PPWD 30 B2 to Dewalt DXVCS002 Adapter — zdjęcie 1
1 / 3

Parkside PPWD 30 B2 to Dewalt DXVCS002 Adapter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Adapter für die Verbindung des Dewalt DXVCS002 Schlauches direkt in den Parkside PPWD 30 B2.

Ocena
3 / 5
Polubienia
7
Pobrania
192
Wydruki
2
Wyświetlenia
873
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Share Alike

Mit dem Adapter kann man den Schlauch des Dewalt DXVCS002 Vorabscheiders direkt in den Parkside PPWD 30 B2 stecken. Der Schlauch des Parkside PPWD 30 B2 Staubsaugers kann direkt ohne Adapter auf den Eingang des Dewalt Vorabscheiders aufgesteckt werden. Mithilfe dieses Adapters kann man also den Saugschlauch des Parkside Staubsaugers wie gewohnt verwenden.

Ausgehend vom Staubsauger ist die Steckreihenfolge dann:
Parkside Staubsauger -> Adapter -> Dewalt Schlauch -> Dewalt Vorabscheider -> Parkside Schlauch -> Parkside Zubehör

Den Adapter sollte man mit 100% Infill und mit PETG drucken, weil sonst der Hebel abbricht, wodurch das Rohr nicht mehr fest bleibt. Der Adapter hat auf der Staubsaugerseite etwas unter den 58mm der Öffnung des Staubsaugers und sitzt daher nur locker drin und fällt ohne den Hebel raus. Der Schlauch des Dewalt Vorabscheiders hat laut Messung 44,69mm Durchmesser. Den Adapter habe ich auf 44,68mm Durchmesser eingestellt, damit er richtig fest sitzt.

---

With this adapter, you can directly insert the hose of the Dewalt DXVCS002 pre-separator into the Parkside PPWD 30 B2. The hose of the Parkside PPWD 30 B2 vacuum cleaner can be connected directly to the inlet of the Dewalt pre-separator without an adapter. So, using this adapter allows you to use the suction hose of the Parkside vacuum cleaner as usual.

Starting from the vacuum cleaner, the connection order is:

Parkside vacuum cleaner -> adapter -> Dewalt hose -> Dewalt pre-separator -> Parkside hose -> Parkside accessories

The adapter should be printed in PETG with 100% infill, otherwise the locking lever may break, causing the pipe to come loose. On the vacuum cleaner side, the adapter is slightly smaller than the 58 mm opening of the vacuum, so it fits only loosely and will fall out without the lever. The hose of the Dewalt pre-separator measures 44.69 mm in diameter. I set the adapter to 44.68 mm to ensure a tight fit.

Tagi