Nikon D50 D70 D70S D80 D90 D100 Battery Door Cover Latch
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The battery door latch for the D50 D70 D70S D80 D90 D100 cameras can break causing the door to not latch shut.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 159
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Share Alike
The battery door latch for the D50 D70 D70S D80 D90 D100 cameras can break causing the door to not properly latch shut.
This is a 3D printable replacement part for the latch.
Print Settings and Recommendations:
0.2mm Layer Height
100% Infill
No Supports
Recommended: Print on a smooth bed plate as the imprinted texture from textured beds can cause the latch to not slide.
Installation:
Hold the battery door at about 45 degrees from the camera bottom
Give it a firm tug to remove
Peel back the paper label
Unscrew the two screws in the metal plate
Remove the broken latch
Replace the latch
Replace the two screws
Reinstall the battery door by pushing it in at a 45 degree angle
