X-Shot Piston Pump Barrel Shroud connector
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This piece attaches your barrel shroud without hurting your barrel collet
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 364
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a part that connects a piston pump (or any other) barrel shroud to your blaster without having to screw directly into the barrel collet.
It is styled like a rail panel and could be used for that instead. To install take the piece and position it like how I have in the photos, then put your m3*30 bolts through and screw them into your m3 nuts. You should be done.
IMPORTANT: YOU MUST PUT THE PART IN THE SAME ORIENTATION WITH THE OVERHANG DOWN YOU ALSO HAVE TO SET BRIDGE SPEED TO 10MM/S AND BRIDGE FLOW TO 1.5 OTHERWISE YOUR PART WILL BE WEAK WITH BAD OVERHANGS NO SUPPORTS
uses like the platypus rail seed